Overview
이 제품은 300m 이상의 범위를 가지는 작고 가벼우며 저렴한 오픈 소스 라디오 플랫폼입니다.
(지상에서 패치 안테나를 사용하여 범위를 몇 킬로미터로 확장할 수 있음)
이 제품은 모든 Pixhawk Standard 및 기타 Flight Controller와 플러그 앤 플레이 방식으로 작동하며,
Autopilot과 지상국 사이에 원격 측정 연결을 가장 쉽게 설정 할 수 있습니다.
MAVLink 패킷과 잘 작동하고 Mission Planner, Ardupilot, QGroundControl, PX4 Autopilot과 통합되도록 특별히 설계된
오픈 소스 펌웨어를 사용합니다.
이 제품은 915Mhz 또는 433Mhz 중 선택 할 수 있으며 해당 국가/지역에 적합한 모델을 구입해야 합니다.
Features
Open-source SIK firmware
Plug-n-play for Pixhawk Standard Flight Controllers
Easiest way to connect your Autopilot and Ground Station
Interchangeable air and ground radio
Micro-USB port (Type-C Adapter Cable Included)
6-position JST-GH connector
Specification
100 mW maximum output power (adjustable) -117 dBm receive sensitivity
RP-SMA connector
2-way full-duplex communication through adaptive TDM UART interface
Transparent serial link
MAVLink protocol framing
Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle
Error correction corrects up to 25% of bit errors Open-source SIK firmware
Configurable through Mission Planner & APM Planner
FT230X / FT231X is a USB to BASIC UART IC
Dimensions
28 x 53 x 10.7mm (without antenna)
Electrical Data
Supply voltage: 5V DC (from USB or JST-GH)
Transmit current: 100 mA at 20dBm
Receive current: 25 mA
Serial interface: 3.3 V UART
Package Included
Radio modules with antennas *2
Micro-USB to USB-A cable *1
Micro-USB to Micro-USB OTG adapter cable *1
Micro USB to Type C Adapter
JST-GH-6P to JST-GH-6P cable *1 (for Pixhawk Standard FC)
JST-GH-6P to Molex DF13 6P (for Pix32, Pixhawk 2.4.6, etc.)